Best Tips for Attic Insulation
Attic insulation is important for any home. It keeps the home temperature heated or cooled. It can also help you save energy and money in the long run. This may also help prolong the roof life in places where the climate is cold. An uninsulated attic will take in heat from the house; this will get enough heat to melt the snow found on the roof. That’s why it’s a requirement to set up attic insulation in your home. The following are some tips for you to consider before you start looking for a Florida attic insulation company:
Make sure that you have sufficient R-value
R-value is the insulation material’s ability to insulate. “R” stands for resistance which means resistance to heat transfer. The higher the R-value of the material is, the better insulation it can provide. The US Department of Energy recommends R-value that ranges from R-30 to R-49.
Avoid the attic ceiling from getting wet
The first thing you must do is to check the attic ceiling or the underside of the roof. Look for stains and watermarks. If water gets into the attic, it is likely for water to get into the insulation. There is no use for wet insulation particularly because water conducts heat quite easily. Also make sure that the exhaust fans’ vents lead to the outside and not the attic. Moist air coming from the bathroom may lead to the insulation which ruins its ability to cease heat transfer.
Make sure that the vents are uncovered
Majority of the attics are vented. This ensures that the temperature inside is the same as the temperature outside. This enables roof life to be prolonged. Air gets into the attic by way of vents in the soffits or the underside of the eaves. This also exits into the other vents within the roof. That’s why when you have to put the insulation in place make sure that the soffit vents are not covered, or else your attic will not receive proper ventilation.
Make sure that all the leaks are sealed
Insulation can only prevent heat from transferring through the use of building materials like drywall, ceiling joints, and ductwork. When air leaks from the conditioned parts of the house into the attic, insulation will not be able to put a stop to it. Hence it is necessary to seal all air leaks before insulation is laid down. It’s better to use any of the following materials: caulk, or use weatherstripping or expanding urethane foam to seal all the leaks.
Be careful of recessed lights
Perhaps there are lighting fixtures that are protruding in the attic. It is crucial to determine thy type of lighting fixture before the insulation is laid down. Recessed lights give off too much heat that can ignite the insulation and cause fire.